China mold maker&plastic injection molding company

Professional & Trustable Plastics Mold Maker

China injection molding making manufacturer

Mold

Home > Article > Mold >

  • China Mould Maker - 2018/06/15

    China Mould Maker process : 1、Injection Molding design control 2、China Mould Maker steel certificated 3、Injection Molding steel hardness inspection 4、injection moulding electrodes inspection etc....

  • Inside slider - 2018/06/15

    Our plastic product design, sometimes close to the design of the card will depend on the hook, or oblique pin strength will be weak and cause mold does not survive, change design and very troublesome.sometimes clever little injection mold design ...

  • Injection Mold inspection - 2018/06/15

    Injection Mold inspection in China . After the injection mold has to go through several test mode, most small and medium molds need to be 1-3 times tryout, medium-sized injection mold takes 3 to 5 times...

  • medical project - 2018/06/15

    mold making project for thermoplastic elastomer molded parts Recently, we produced three molds for Austrian companies, injection molding products are thermoplastic elastomer...

  • Reliable mold making company - 2018/06/15

    You can find why Cnmoulding is really high quality mold Maker in china ,Difference with other Mold Making Quality control process...

  • Sink Mark - 2018/06/04

    Plastic injection molding products sink mark, its causes and solutions:Cooling contraction in wall thickness, the material has a dent on stiffener or sink hole phenomenon ...

  • Cooling - 2018/06/04

    China Injection Mold Cooling System, In order to control the injection mold temperature, 100 degrees below, usually adopts water as cooling medium ...

  • cost control - 2018/06/04

    To ensure that the cost of mold, cost control and quality and delivery is proportional to the relationship between the quality of the mold to do a one-time, few changes, delivery to shorten...

Facebook Twitter YouTube LinkedIn

Contact Us

Copyright 2013 www.chinamoldmaker.org All Rights Reserved.
Top↑